E-mail: michael@shboqu.com   |   Expert in Water Quality Measurement and Water Treatment Project

Precautions for the use of residual chlorine meter

by:BOQU     2023-04-06
Precautions for using the residual chlorine meter The residual chlorine meter is an online residual chlorine analysis instrument, which is composed of a residual chlorine sensor and a residual chlorine meter. It can measure residual chlorine and temperature at the same time. It is widely used in electric power, water supply, medicine, chemical industry, food And other industries, continuous measurement of residual chlorine in water. 1. The instrument has been calibrated by the factory before leaving the factory and does not require user calibration. 2. The user should use the free chlorine (total chlorine) DPD reagent provided by the manufacturer when measuring the instrument. 3. If the temperature of the water sample is lower than 15°C, it should be preheated to above 15°C after adding the medicine (wrap the sample cell with a layer of paper and shake it with your hands), until the medicine is completely dissolved, and then measure. 4. Sampling samples must be analyzed immediately and cannot be saved for later analysis. 5. When the sample cell is inserted into the sample cell slot, the sample cell must be correctly positioned and locked (the sample cell is placed in the sample cell slot, so that the triangular mark on the bottle cap is aligned with the triangular positioning mark on the instrument) to prevent stray light Enter. After the sample cell is installed in the sample cell tank, it should be kept still for at least 30 seconds (to allow the air bubbles in the sample to be eliminated and the solid particles to settle) before measurement. 6. After one measurement (residual chlorine or total chlorine measurement), the sample cell must be thoroughly cleaned before using the same sample cell for another measurement. 7. The sample cell and bottle cap must be cleaned immediately after measurement to prevent contamination and corrosion of the sample cell. 8. If solid or solution enters the sample cell, it must be cleaned up before being put into the sample cell. When the 'READ' key is pressed continuously, if the reading increases or the reading is unstable (nearly before '- - - L' appears), it means that the battery voltage is insufficient, and the battery should be replaced and measured again. 9. The standardization of the time used to control each step is crucial to improving the precision of the determination. The color development can be stable for about 5 minutes at a concentration of 0.5 mg/L, and the color development can be stable for about 2 minutes at a concentration of 2.0 mg/L. 3.0 The color development at a concentration of about mg/L can be stable for about 1 minute. 10. When the concentration of the measured water sample is greater than the measuring range of the instrument, the reading of the instrument will overflow and cannot be read. At this time, the water sample to be tested should be diluted to an appropriate concentration with distilled water or deionized water for measurement. The concentration value of the tested water sample is calculated according to the following formula:
Shanghai Boqu Instrument Co., Ltd. specializes in undertaking corporate offers to cater the needs of different companies.
For decades, Shanghai Boqu Instrument Co., Ltd. has searched for and found a number of secrets to help customers through out the world to achieve water quality monitoring device by providing useful and efficient solutions. Go to BOQU Water Quality Analyzer to learn about some of those secrets.
Overwhelming customers with too much information or the slew of benefits water analyzer provides–even if they're all valid–is a surefire way to lose their attention.
Latest technology and manufacturing equipment has improved the quality of water analyzer.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...