Secondary water supply water quality monitoring system cleaning steps

Water is an indispensable part of our life, but some water quality that is not treated frequently is usually relatively turbid, and the treated water cannot guarantee that it can meet our daily use. In order to avoid poor water quality and life. However, after the system has been running for a long time, it will be affected by the adsorption of some bacteria and algae in the water quality. At this time, in order to ensure that the inside of the system is clean state, it needs to be cleaned, let me tell you about the cleaning steps of the secondary water supply water quality monitoring system. Cleaning steps of the secondary water supply water quality monitoring system 1. The connection valve between the main water inlet valve and the water tank needs to be closed during cleaning, and the drain valve should be opened to drain the water in the pool or water tank. 2. Keep the drain water valve in the open state, and use the blower to blow the water to the pool or water tank for more than 2 hours, so as to facilitate the inflow of air and reduce the toxic gas in the pool and water tank. 3. Use a burning candle to place it on the bottom of the pool. If it does not go out after waiting for a period of time, there will be no lack of oxygen in the surface pool. After installing the lighting, the pool can be cleaned. 4. The cleaning personnel should strictly scrub every part of the pool to ensure that it is in a clean state, and then the inspectors should check the pipes, floats, water level controllers and other devices in the pool (tank). 5. After cleaning, it is necessary to drain the sewage in the pool (box), and then spray disinfectant water into the pool (box). 6. After waiting for half an hour, rinse the pool (tank) again. Generally, it needs to be disinfected three times, and all the sludge at the bottom of the pool needs to be cleared, and then the accumulated water in the pool needs to be pumped out through the submersible pump. 7. It should be noted that while cleaning the pool, it is also necessary to check and clean the fastening valve and clean the filter screen. 8. When the above steps are completed, you can fill the pool with water, and then take some samples to the municipal health and epidemic prevention testing station for testing and evidence collection. It is very necessary to clean the secondary water supply water quality monitoring system. It can ensure that the water quality we use will not be polluted, and it does not need to be cleaned frequently, and the maintenance cost is relatively low.