TSS Meter Factory, Total Suspended Solids Meter Supplier

tss meter/ total suspended solids sensor - Boqu

ZDYG-2087 ONLINE SUSPENDED SOLIDS METER

Description of Suspended Solids (Sludge Concentration) Sensor

The total suspended solids sensor is based on the infrared absorption scattered light method and combined with the application of ISO7027 method, can guarantee the continuous and accurate detection of suspended solids and sludge concentration. Based on ISO7027, infrared double scattering light technology will not be affected by chroma for the measurement of cuspended colids and cludge concentration value. According to the usage environment, self-cleaning function can be equipped with. The tss meter assures the stability of data and reliability of performance; with the built-in self-diagnosis function, it can make sure the accurate data is delivered; besides, the installation and calibration are quite simple.

TECHNICAL INDEXES

Technical indexes of tss meter/ total suspended solids sensor

Specifications	Details
Size	Diameter 60mm* Length 256mm
Main Materials	Main Body:SUS316L (Ordinary Version),Titanium Alloy (Seawater Version) Upper and Lower Cover：PVC；Cable: PVC
Waterproof Rate	IP68/NEMA6P
Measurement Range	0.01-20000 mg/L、0.01-45000 mg/L 、0.01-120000 mg/L
Indication Resolution	Less than ± 5% of the measured value (depending on sludge homogeneity)
Pressure Range	≤0.4Mpa
Flow velocity	≤2.5m/s、8.2ft/s
Storage Temperature	-15~65℃
Environment Temperature	0~45℃
Calibration	Sample Calibration, Slope Calibration
Cable Length	Standard 10-Meter Cable, Max Length: 100 Meters
Warranty Period	1 Year
High Voltage Baffle	Aviation Connector, Cable Connector
External Dimension

TSS meter supplier/ total suspended solids sensor manufacturer

SUSPENDED SOLIDS METER

The suspended solid meter can be used to display data measured by the sensor, so the user can get the 4-20mA analog output of the transmitter’s interface configuration and calibration. And our tss meter can make relay control, digital communications, and other functions a reality.

The total suspended solids sensor is widely used in sewage plants, water plants, water stations, surface water, farming, industry and other fields. The transmitter diagram is shown in the figure.

MAIN FEATURES

Main features of TSS meter supplier/ total suspended solids sensor

Relay, output and the signal

The transmitter is equipped with three configurable relay switches and two-way analog output.

Sensor and the sensor module

The transmitter is a single-parameters one, can contain one sensor.

Transmitter shell

Transmitter shell is of IP65 protection class. For outdoor use, it’s strongly recommended to take protective measures to prevent environmental damage.

Specification	Details
Size	145125162mm LWH
Material of outside shell	Lower casing：Aluminum with powder covering
Material of outside shell	Cover：PA66+GF25+FR
Waterproof Rate	IP65/NEMA4X
Storage Temperature	-20 to 70℃
Operation Temperature	-15 to 60℃
Power Supply	AC：AC220V, 50HZ, 5W DC：DC24V
Output	Two-way analog output 4-20mA, response parameters and corresponding scope can be programmed; Note: the maximum load is 500 ohms
Relay	Three-way relay can be set up, and response parameters and response values can be programmed
Display Output	128 * 64 dot matrix LCD with LED backlight, which can be operated under the direct sunlight
Digital Communication	MODBUS RS485 communication function, which can transmit real-time measurements
Warranty Period	1 year

Online Suspended Solids Meter ZDYG-2087